Starting and ramping up an ESP with a PMM

Field and shop procedures for ESP installation, pull, commissioning, and related work instructions, including operator ETT (Unified Technical Requirements).
ALEngineer
Site Admin
User avatar
Posts: 579
Joined: Wed Mar 18, 2026 2:51 pm

Starting and ramping up an ESP with a PMM

Post by ALEngineer »

Instruction for the electrician on starting and ramping up an ESP with a permanent magnet motor (PMM).

When voltage is applied to the stator winding, alternating current flows in it and a rotating magnetic field appears. The magnetic field of the rotor permanent magnets interacts with the stator rotating field and produces torque.

Unlike an induction ESP motor, the stator of a PMM is fed a non-sinusoidal voltage (pulses). The amplitude is changed automatically by the VSD with shaft load and with the lag angle of the rotor behind the stator field.

A PMM is also an AC generator: if the shaft is turned by an outside force (for example turbine rotation) with no supply on the stator, voltage appears at the stator terminals. That voltage is proportional to shaft speed. At rated speed the terminal voltage equals the rated value.
PMM ESP start and ramp-up.zip
Original topic
ИНСТРУКЦИЯ по запуску и ВНР УЭЦН с вентильным двигателем для электромонтера. При подаче напряжения на обмотку статора, в ней протекает переменный ток и возникает вращающееся магнитное поле. Магнитное поле постоянных магнитов ротора взаимодействует с вращающимся магнитным полем статора, образуя вращающий момент.

В отличие от асинхронного, на статорную обмотку вентильного электродвигателя подаётся несинусоидальное напряжение (импульсы), амплитудное значение которого изменяется автоматически станцией управления в зависимости от нагрузки на валу и, соответственно, угла отставания ротора от магнитного поля статора.

Вентильный электродвигатель является генератором переменного напряжения, т.е. без подачи питающего напряжения на статорную обмотку при условии вращения вала внеш-ними силами (например при турбинном вращении) на выводах статорной обмотки возникает напряжение. Величина напряжения прямо пропорциональна частоте вращения вала. Таким образом при номинальной частоте вращения вала двигателя на выводах обмотки ста-тора возникает напряжение равное номинальному значению.
PMM ESP start and ramp-up.zip
You do not have the required permissions to view the files attached to this post.
SamokhvalMA
Posts: 7
Joined: Fri Dec 06, 2013 2:31 am

Re: Starting and ramping up an ESP with a PMM

Post by SamokhvalMA »

Start instruction for a PMM from an Elekton VSD.

The electrician memo for setting up Elekton-05 VD (PMM VSD) is missing from the archive (Kunena file not recovered by path or size).
Original reply
Инструкция запуска ВПЭД с СУ Электон.