Installing an ESP motor shroud

Field and shop procedures for ESP installation, pull, commissioning, and related work instructions, including operator ETT (Unified Technical Requirements).
ALEngineer
Site Admin
User avatar
Posts: 579
Joined: Wed Mar 18, 2026 2:51 pm

Installing an ESP motor shroud

Post by ALEngineer »

The shroud is for cooling EDB-103 and EDB-117 motors with a downhole monitoring system (TMS) and a single-housing protector (type 1PB92) when the unit is run below the perforation interval in wells with nominal ID 130 mm and 150 mm.

The shroud keeps the ESP motor from overheating, lets you ramp up after workover without stopping the motor to cool, reduces the effect of associated gas, and raises well rate.

Length match of Borets ESP motors and shrouds is in the small zip.
Borets ESP motor vs shroud lengths.zip
ESP motor shroud installation.zip
Original topic
Кожух предназначен для обеспечения охлаждения двигателей типа ЭДБ-103, ЭДБ-117 с системой погружной телеметрии (ТМС) и однокорпусным протектором (типа 1ПБ92) при эксплуатации ниже интервала перфорации в скважинах условным внутренним диаметром 130 и 150 мм.
Использование кожуха предохраняет электродвигатель от перегрева, позволяет после ремонта скважины выводить установку на режим без остановок двигателя для охлаждения, снижает вредное влияние попутного газа и увеличивает дебит скважины.
Соответствие длин ПЭД и кожухов производства ООО "ПК "Борец"
Borets ESP motor vs shroud lengths.zip
ESP motor shroud installation.zip
You do not have the required permissions to view the files attached to this post.